Error Code
429
Problem Solving
15
016-747
[Cause] The memory became insufficient when using the Repeat Image feature and
the Annotations features simultaneously.
[Remedy] Take one of the following measures:
z
Increase the annotation image size.
z
Reduce the usage of Repeat Image.
z
Increase memory.
016-748
[Cause] Unable to print because of insufficient hard disk space.
[Remedy] Reduce the number of print pages by dividing the print data or by printing one
copy at a time when printing multiple copies.
016-749
[Cause] Probable causes are as follows:
For a print job:
1) The printer language received from the print driver is unsupported by this
machine.
For printing of a document received by Internet Fax:
2) The printer language of the document received from the remote machine is
unsupported by this machine.
[Remedy] For 1), use the machine’s print driver for printing. If the error still is not
resolved, contact our Customer Support Center.
For 2), request the sender to send Internet fax documents using a printer
language supported by the machine.
Note • An optional component must be installed for some printer languages such as
PostScript. For more information, contact our Customer Support Center.
016-750
[Cause] The machine received a PDF, an XPS, and a printing job ticket from an
application (such as ContentsBridge) that allows direct transmissions of files,
but the printing job ticket data had a grammar or print instruction unsupported
by the machine.
[Remedy] Check whether you are correctly using the application (such as
ContentsBridge) and whether the print instruction was correct.
If your application usage and print instruction are correct, check with the
application manufacturer that sent the print job for operations of the
application.
If the error still is not resolved, have the Configuration Report, the Job History
Report, and the print data with the printing job ticket ready, and contact our
Customer Support Center.
016-751
[Cause] Probable causes are as follows:
1) During the PDF Bridge processing, a syntax or parameter error occurred,
an undefined command was used, and a PDF file was damaged.
2) When [Print Processing Mode [408])] for the PDF Direct Print feature has
been set to [PS([1])], memory is insufficient.
3) When [Print Processing Mode [408])] for the PDF Direct Print feature has
been set to [PS([1])], a PDF file including OpenType fonts is processed.
[Remedy] For 1), use the print driver to print the document.
For 2), take one of the following measures:
z
Use the print driver to print the document.
z
Increase PostScript memory.
For 3), create a PDF file in which OpenType fonts are not included.
For more information on the memory, refer to "Allocate Memory" (P.169).
016-752
[Cause] Unable to process for PDF Bridge because of insufficient memory space.
[Remedy] Change the [Image Quality] setting from [High Resolution] to [High Quality],
or from [High Quality] to [Standard]. Or, add memory.
016-753
[Cause] The password entered does not match that of the PDF file.
[Remedy] Set the correct password on ContentsBridge.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Downloaded From ManualsPrinter.com Manuals