Fuji Xerox DocuCentre-IV 2060 Administrator's Guide

15 Problem Solving
454
Problem Solving
15
027-443
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 2] for IPv6 on the machine, or the IP
address of IPv6 on the network device, to remove the duplication of
addresses.
027-444
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 3] for IPv6 on the machine, or the IP
address of IPv6 on the network device, to remove the duplication of
addresses.
027-445
[Cause] IP address for IPv6 set manually is incorrect.
[Remedy] Set the IP address correctly.
027-446
[Cause] The IP address of IPv6 set manually already exists.
[Remedy] Change the [Manually Configured IPv6 Address] on the machine, or the IP
address of IPv6 on the network device, to remove the duplication of
addresses.
027-447
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Link-local Address] for IPv6 on the machine, or the IP address of
IPv6 on the network device, to remove the duplication of addresses.
027-452
[Cause] IP address already exists.
[Remedy] Change the IP address set on the machine.
027-500
[Cause] Unable to connect to the SMTP server.
[Remedy] Specify the SMTP server name correctly or specify the server by using its IP
address.
027-501
[Cause] An POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our
Customer Support Center.
027-502
[Cause] Failed to log into the POP3 server when using the POP3 protocol.
[Remedy] Confirm whether the user name and password used in the POP3 server are
correct on CentreWare Internet Services.
027-503
[Cause] An POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our
Customer Support Center.
027-504
[Cause] A SMTP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our
Customer Support Center.
027-513
[Cause] The machine failed to transfer data using SMB of the Scan to PC service
because access to the SMB server was not permitted.
When the server is Macintosh, a folder with the same name as the specified
file name may exist on the server.
[Remedy] Change the settings so that a file or a folder can be read and written at the
save location.
When the server is Macintosh, change the folder name on the server, or the
name of the file to be transferred.
027-514
[Cause] The machine failed to transfer data using SMB of the Scan to PC service
because an error has been occurred between the SMB server and the DNS
server.
[Remedy] Check the following conditions:
z
The SMB server is connected to the DNS server.
z
The SMB server name is registered on the DNS server.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Downloaded From ManualsPrinter.com Manuals

Fuji Xerox DocuCentre-IV 2060 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV 2060
Category	All in One Printer
Language	English