Using the Operator Panel Menus and Keypad 152
•N-Up
Purpose:
To print two original pages to fit onto one sheet of paper.
Values:
• Margin Top/Bottom
Purpose:
To specify the value of the top and bottom margins.
Values:
• Margin Left/Right
Purpose:
To specify the value of the left and right margins.
Values:
• Margin Middle
Purpose:
To specify the value of the middle margin.
Values:
Scan Defaults
Use the Scan Defaults menus to configure a variety of scanner features.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
Off* Does not perform N-Up printing.
Auto Automatically reduces the original pages to fit onto one sheet of
paper.
ID Card Copy Prints the original pages onto one sheet of paper in the original size.
Manual Prints the original pages onto the one sheet of paper in the size
specified in Reduce/Enlarge.
4 mm*/0.2 inch* Specify the value in increments of 1 mm/0.1 inch.
0-50 mm/0.0-2.0 inch
4 mm*/0.2 inch* Specify the value in increments of 1 mm/0.1 inch.
0-50 mm/0.0-2.0 inch
0 mm*/0.0 inch* Specify the value in increments of 1 mm/0.1 inch.
0-50 mm/0.0-2.0 inch
To Next Page
Loading...
Need help?
General
