Troubleshooting 200
Mottle
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji
Xerox local representative office or an authorised dealer.
Problem Action
The printed result has mottled
appearance.
Adjust the transfer bias.
1 Launch the Printer Setting Utility, click Adjust BTR on the Printer
Maintenance tab.
2 Adjust the setting for the type of print media being used.
3 Click Apply New Settings button.
If you use non-recommended print media, use the print media
recommended for the printer.
To Next Page
Loading...
Need help?
General
