Fuji Xerox DocuPrint M205 b

171 Using the Operator Panel Menus and Keypad
 Enabling the Panel Lock
1 Press the (System) button.
2 Select Admin Menu, and then press the button.
3 Select Secure Settings, and then press the button.
4 Select Panel Lock, and then press the button.
5 Select Panel Lock Set, and then press the button.
6 Select Enable, and then press the button.
7 As necessary, select Change Password, and change the password using the numeric keypad.
Then, press the button.
NOTE:
• The factory-default password is 0000.
NOTE:
• The procedure described below allows you to reset the password.
Turn off the printer. Then, while holding the (System) button, turn on the printer.
• If you change the password while Panel Lock is Enable, perform steps 1 to 4. Select Change Password,
and then press the button. Enter the new password, and then press the button. This will change the
password.