Using the Operator Panel Menus and Keypad 160
Admin Menu
Use the Admin Menu menu to configure a variety of printer features.
NOTE:
• A Password is required to enter the Admin Menu when Panel Lock Set is set to Enable. In this case,
enter the password you specified, and press the button.
System Settings
Use the System Settings menu to configure a variety of printer features.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Power Saving Timer
Purpose:
To specify the time for transition to the Power Saver mode.
See also:
• "Setting the Power Saving Timer Option" on page 174
Values:
Enter 1 in Low Power Timer to put the printer in the Low Power mode one minute after it finishes a
job. This uses less energy, but requires more warm-up time for the printer. Enter 1 if your printer
shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer
ready to operate with minimum warm-up time. Select a value between 1 and 30 minutes for the Low
Power mode if you want a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the Power Saver mode when it receives
data from the computer. You can also return the printer to the standby mode by pressing any button on
the operator panel.
• Auto Reset
Purpose:
To automatically reset the settings for copy or scan to the defaults and return to the standby mode
after you do not specify any settings for the specified time.
Values:
Low Power Timer 1min* Specifies the time taken by the printer before it enters the Low
Power mode after it finishes a job.
1-30min
Sleep Timer 10min* Specifies the time taken by the printer before it enters the
Sleep mode after it goes into the Low Power mode.
6-11min
45sec*
1min
2min
3min
4min
To Next Page
Loading...
Need help?
General
