175 Using the Operator Panel Menus and Keypad
Resetting to Factory Defaults
After executing Initialize NVM and rebooting the printer, the menu parameters or data are reset to their
factory default values.
1 Press the (System) button.
2 Select Admin Menu, and then press the button.
3 Select Maintenance, and then press the button.
4 Select Initialize NVM, and then press the button.
5 Select System Section, and then press the button.
6 Select Yes, and then press the button.
The printer restarts automatically to apply the settings, and then initial settings start.
See also:
• "Setting Initial Settings on the Operator Panel" on page 40
To Next Page
Loading...
Need help?
General
