Fujitsu ETERNUS DX S5 Series - Figure 26 Rear View of a Controller Enclosure (When the ETERNUS DX100 S5;DX200 S5 Is Installed with Two Controllers)

Figure 26 Rear View of a Controller Enclosure (When the ETERNUS DX100 S5/DX200 S5 Is Installed with Two
Controllers)
1 1
2 4 5 3 5 32 3 46 6
7
7
3
PSU#0 PSU#1
CA#0
CM#0 CM#1
CA#1 CA#0 CA#1
1 Controller (CM#0, CM#1) (refer to "
■ Controllers" (page 109))
2 PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
3 Host interfaces (CA#0, CA#1) (refer to "■ Host Interface" (page 116))
4 Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
5 RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
6 MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
7 Power supply units (PSU#0, PSU#1) (refer to "■ Power Supply Units" (page 114))
A. Component Names
Controller Enclosure
101 Operation Guide (Basic)