Fujitsu ETERNUS DX S5 Series - Figure 25 Rear View of a Controller Enclosure (When the ETERNUS DX100 S5;DX200 S5 Is Installed with Only One Controller)

■
ETERNUS DX100 S5/DX200 S5
Figure 25 Rear View of a Controller Enclosure (When the ETERNUS DX100 S5/DX200 S5 Is Installed with Only
One Controller)
7
1
2 4 5 3
8
8
63
PSU#0 PSU#1
CA#0
CM#0
CA#1
1 Controller (CM#0) (refer to "■ Controllers" (page 109))
2 PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
3 Host interfaces (CA#0, CA#1) (refer to "■ Host Interface" (page 116))
4 Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
5 RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
6 MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
7 Cover
Remove this when installing an additional controller (optional).
8 Power supply units (PSU#0, PSU#1) (refer to "■ Power Supply Units" (page 114))
A. Component Names
Controller Enclosure
100 Operation Guide (Basic)