Controller Enclosure
An operation panel and drives are installed in the front of the ETERNUS DX controller enclosure. Controllers and
power supply units are installed in the rear.
Front
This section provides the names of the components in the front of a controller enclosure.
■
ETERNUS DX60 S5/DX100 S5/DX200 S5
Figure 17 Front View of a 2.5" Type Controller Enclosure (ETERNUS DX60 S5/DX100 S5/DX200 S5)
Slot#0
Slot#1
Slot#2
Slot#3
Slot#4
Slot#5
Slot#6
Slot#7
Slot#8
Slot#9
Slot#10
Slot#11
Slot#12
Slot#13
Slot#14
Slot#15
Slot#16
Slot#17
Slot#18
Slot#19
Slot#20
Slot#21
Slot#22
Slot#23
1
3 3
2
1 Operation panel (refer to "
■ Operation Panel" (page 105))
2 2.5" drive (refer to "■ Drives" (page 108))
3 Flange cover
Figure 18 Front View of a 3.5" Type Controller Enclosure (ETERNUS DX60 S5/DX100 S5/DX200 S5)
1
3 3
2
Slot#0 Slot#3Slot#1 Slot#2
Slot#4
Slot#8
Slot#11
Slot#7Slot#5
Slot#6
Slot#9 Slot#10
1 Operation panel (refer to "
■ Operation Panel" (page 105))
2 3.5" drive (refer to "■ Drives" (page 108))
3 Flange cover
A. Component Names
Controller Enclosure
95 Operation Guide (Basic)
To Next Page
Loading...
