Fujitsu ETERNUS DX S5 Series - Figure 36 Controller (for the ETERNUS DX100 S5;DX200 S5, Pattern 1); Figure 37 Controller (for the ETERNUS DX100 S5;DX200 S5, Pattern 2); Table 19 Status and Meaning of each LED (Controller for the ETERNUS DX100 S5;DX200 S5)

LED name LED status Meaning
READY/FAULT
(green)
The controller is in normal status.
(blinks green)
An error has occurred during startup.
(amber)
• The controller is performing the initial setup after the power is
turned on.
• The controller is in error status.
(blinks amber)
CA FAULT
(amber)
The host interface is in error status.
MASTER
(green)
The controller is set as a Master CM.
● ETERNUS DX100 S5/DX200 S5
Figure 36 Controller (for the ETERNUS DX100 S5/DX200 S5, Pattern 1)
IDENTIFY/BBU FAULT LED
DI (OUT) LINK/FAULT LED
CA#0 FAULT LED
READY/FAULT LED
CA#1 FAULT LED
LAN ACT LED
LAN LINK LED
LINK/FAULT LED
MASTER LED
LINK/FAULT LED
LAN ACT LED
L
AN LINK LED
Figure 37 Controller (for the ETERNUS DX100 S5/DX200 S5, Pattern 2)
IDENTIFY/BBU FAULT LED
D
I (OUT) LINK/FAULT LED
LAN ACT LED
LAN LINK LED
READY/FAULT LED
CA#0 FAULT LED
MASTER LED
CA#1 FAULT LED
LINK/FAULT LED
LINK/FAULT LED
LAN ACT LED
LAN LINK LED
Table 19 Status and Meaning of Each LED (Controller for the ETERNUS DX100 S5/DX200 S5)
LED name LED status Meaning
IDENTIFY/BBU FAULT
(blinks blue)
The installation location of the controller is identified according to
the instruction that is issued from ETERNUS Web GUI or ETERNUS CLI.
(amber)
The battery is in error status.
A. Component Names
Controller Enclosure
110 Operation Guide (Basic)