■
ETERNUS DX600 S5
Figure 28 Rear View of a Controller Enclosure (ETERNUS DX600 S5)
8 8
1 1
9 9
CPSU#0
CPSU#1
CA#0
CA#1
CA#0
CA#1
CA#2
CA#3CA#2
CA#3
2 2
CM#0
CM#1
BUD#1
BUD#0
BUD#1
BUD#0
543 76
1 Controllers (CM#0, CM#1)
(Refer to "■ Controllers" (page 109
).)
2 Host interfaces (CA#0, CA#1, CA#2, CA#3)
(Refer to "■ Host Interface" (page 116).)
3 RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
4 MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
5 FST (LAN) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
6 Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
7 PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
8 Power supply units (CPSU#0, CPSU#1)
(Refer to "■ Power Supply Units" (page 114).)
9 BUD (BUD#0, BUD#1)
(Refer to "■ BUD" (page 121).)
A. Component Names
Controller Enclosure
103 Operation Guide (Basic)
To Next Page
Loading...
