Fujitsu ETERNUS DX S5 Series - Figure 46 Host Interface Ports (ETERNUS DX500 S5;DX600 S5); Table 26 Status and Meaning of each LED (Host Interface for the ETERNUS DX500 S5;DX600 S5)

LED name LED status Meaning
FAULT
(green)
The link between the host interface port (iSCSI) and the
destination port has been established.
LINK
(amber)
The host interface port (iSCSI) is in error status.
● ETERNUS DX500 S5/DX600 S5
There are seven types of host interfaces: FC 32Gbit/s, FC 16Gbit/s, iSCSI 10Gbit/s (10GBASE-SR / 10GBASE-CR),
iSCSI 1Gbit/s, Ethernet 10Gbit/s, and Ethernet 1Gbit/s.
Figure 46 Host Interface Ports (ETERNUS DX500 S5/DX600 S5)
FC 4 portsFC 2 ports
iSCSI 10Gbit/s (10GBASE-SR)
iSCSI 10Gbit/s (10GBASE-CR)
Ethernet 10Gbit/s
(for Copper Twinax cable connection)
iSCSI 1Gbit/s
Ethernet 1Gbit/s
LINK/FAULT LED
CA FAULT LED
CA READY LED
LINK/FAULT LED
LINK/FAULT LED
LINK/FAULT LED
LINK/FAULT LED
Port#0 Port#1
Port#0 Port#1
Port#0 Port#1
Port#2 Port#3
Port#0 Port#1
Port#2 Port#3
Port#0 Port#1 Port#2 Port#3
The states of LEDs are listed below.
Table 26 Status and Meaning of Each LED (Host Interface for the ETERNUS DX500 S5/DX600 S5)
LED name LED status Meaning
CA FAULT
(amber)
The host interface is in error status.
CA READY
(green)
The host interface is in normal status.
LINK/FAULT
(green)
The link between the host interface port and the destination
port has been established.
(amber)
The host interface port is in error status.
A. Component Names
Controller Enclosure
118 Operation Guide (Basic)