1 Controllers (CM#0, CM#1) (refer to "■ Controllers
" (page 109))
2 PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
3 Host interface
This interface is used for connecting a controller with a server.
4 Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
5 RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
6 MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
7 Power supply units (PSU#0, PSU#1) (refer to "■ Power Supply Units" (page 114))
A. Component Names
Controller Enclosure
99 Operation Guide (Basic)
To Next Page
Loading...
