Operational Procedure
1 After a multifeed error occurs, either press the [Eject] button to eject the document from the paper
path, or open the ADF to remove the document.
When the document is removed, the display on the operator panel LCD changes as follows:
Upon multifeed Upon ejecting document
Multifeed detected (Overlap)
Press the iMFF button to eject the document and to suppress multifeed
detection from next scans.
Press the Eject button to eject the document.
When [Ready] is displayed, increase the paper separation force by using
the [
] button to suppress multifeeds. (*1)
[Ready (Multifeed)] screen
Multifeed detected (Overlap)
Press the Eject button to eject the document.
When [Ready] is displayed, increase the paper separation force by using
the [
] button to suppress multifeeds. (*1)
Multifeed detected (Overlap)
Press the iMFF button to memorize the multifeed pattern and eject the
document. Press the Eject button to eject the document.
When [Ready] is displayed, increase the paper separation force by using
the [
] button to suppress multifeeds. (*1)
Multifeed detected (Overlap)
Press the iMFF button to memorize the multifeed pattern. Press the Eject
button to eject the document.
When [Ready] is displayed, increase the paper separation force by using
the [
] button to suppress multifeeds. (*1)
Multifeed detected (Length)
Press the Eject button to eject the document.
[Ready] screen
*1:When the paper separation force is set to [ ] which is the maximum level, the message "When
[Ready] is displayed, increase the paper separation force by using the [ ] button to suppress
multifeeds." does not appear.
2 Place the removed document back on the hopper.
If a multifeed error is detected while no paper is attached on the document, press the [Scan/Pause] button or
restart scanning via the computer (do not press the [iMFF] button). If there is a paper attachment on the
Various Ways to Scan
112
To Next Page
Loading...
