Settings Related to Maintenance/Options
Setting the Maintenance/Inspection Cycles for the Scanner [Maintenance and
Inspection Cycle]
You can specify the cycle of regular maintenance/inspection by a service engineer.
A message for regular maintenance appears when the time specified here elapses after the last time regular
maintenance/inspection was performed. Messages for regular maintenance can be checked in [Information] of the
operator panel.
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the list on the left, select [Device Setting 2] → [Maintenance and Inspection Cycle].
3 Select whether to enable or disable [Maintenance and Inspection Cycle].
When you enable this setting, select a cycle for maintenance/inspection by a service engineer.
Operational Settings
266
To Next Page
Loading...
