Replacing the Brake Roller
Replace the brake roller in following procedure.
1 Turn off the scanner, unplug the power cable and wait for at least 15 minutes.
For details, refer to How to Turn the Power OFF (page 21).
2 Remove all documents from the stacker.
3 If the hopper has been raised, bring it back down to the lower position.
For details, refer to Setting the Loading Capacity of the Hopper (page 31).
4 Open the ADF.
For details, refer to How to Open the ADF (page 26).
When the ADF is open, it might close accidentally. Be careful not to get your fingers
caught.
Replacing the Consumables
147
To Next Page
Loading...
