Settings Related to Scanning
Adjusting the Starting Position for Scanning [Offset Setting/Vertical
magnification Adjustment]
When the output position of the scanned image is not correct or the image appears shortened/elongated
(vertically), use the following procedure to adjust the offset and the vertical magnification for correction.
ATTENTION
Normally, you should not have to make any adjustments as the factory default settings are configured at
appropriate values.
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the list on the left, select [Device Setting] and click the [Offset] button.
Operational Settings
223
To Next Page
Loading...
