Specifying the Cycle to Replace Consumables [Life Counter Alarm Setting]
You can specify the replacement cycle of the consumables.
The background color of the counter changes to light yellow when the page count after replacing the consumable
reaches 95% of the value specified here, and turns yellow when it reaches 100%.
In addition, the Message for replacing consumables (page 219) is displayed.
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the list on the left, select [Device Setting 2] → [Life Counter Alarm Setting].
3 Specify a value for the life cycle for replacing each consumable (pick roller, separator roller and brake
roller).
The specifiable value is from 10,000 to 2,550,000 in increments of 10,000.
Operational Settings
222
To Next Page
Loading...
