Items Configurable in the Main Menu
Item Description Setting/Value Factory Default
- : No settings/values
1: iMFF Setting When there is paper of the same size
attached to a designated location on the
page, configure the scanner to memorize
the location of the attachment and not
detect multifeeds for that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] for the multifeed
detection setting in Specifying a Multifeed
Detection Method [Multifeed] (page 252)
or the scanner driver's setup dialog box.
By selecting [4: Clear pattern], you can
clear the overlapping patterns (length,
location) that were previously memorized
in Auto mode.
It can also be configured from the Software
Operation Panel.
1: Manual mode
2: Auto mode 1
3: Auto mode 2
4: Clear pattern
1: Manual mode
2: No. of Paper
Feed Retries
Configure this setting to change the
number of feeding retries when a pick
error occurs.
It can also be configured from the Software
Operation Panel.
1 to 12 (times) 3
3: Pick Speed When you experience frequent multifeeds
and paper jams, the symptom may be
improved by slowing down the speed at
which the documents are fed (pick speed).
It can also be configured from the Software
Operation Panel.
1: Normal
2: Slow
1: Normal
4: Soft Pick
Setting
When you experience pick errors from the
separator roller slipping on the paper, or
paper jams from scanning thin papers of
small widths, the symptom may be
improved by bringing down the pick roller
unit and keeping the unit at the lower
position (disabling the Soft Pick Setting).
It can also be configured from the Software
Operation Panel.
1: Disable
2: Enable
2: Enable
How to Use the Operator Panel
89
To Next Page
Loading...
