Item Description Setting/Value Factory Default
- : No settings/values
5: Manual
Feed Timeout
Specify the waiting time to clear Manual
Feed mode.
It can also be configured from the Software
Operation Panel.
5, 10, 20, 30, 40, 50, 60,
70, 80, 90, 100, 110, 120,
180, 240, 300, 360, 420,
480, 540, 600, 900, 1200,
1500, 1800, 1999
(seconds)
10
6: Paper
Protection
Specify whether to enable or disable Paper
Protection.
Enabling this setting reduces the risk of
having your documents damaged in such
ways, by stopping the scan when the
scanner detects a document that is
unusually warped.
You can specify the sensitivity to detect an
abnormal feeding of documents when
Paper Protection is enabled.
Documents are deformed (e.g. warped,
bent, creased) when they are not being
fed by the rollers properly. To detect such a
symptom and stop the scan, select [1:Low]
to only detect documents that are highly
deformed, and [3:High] to also detect
documents that are slightly deformed.
Paper Protection is disabled in Manual
Feed mode.
Enable/Disable can also be configured
from the scanner driver's setup dialog box
or the Software Operation Panel. Note that
priority is given to the scanner driver
setting unless you have prioritized the
operator panel setting.
Sensitivity can also be configured from the
Software Operation Panel. Note that if you
have prioritized the operator panel
setting , priority is given to the operator
panel setting.
1: Enable
2: Disable
Sensitivity:
1: Low
2: Normal
3: High
2: Disable
Sensitivity:
2: Normal
7: MF Quick
Change
Enables you to switch whether or not to
detect multifeed by a push of a button.
Priority is given to the scanner driver
setting when [1: Disable] is selected.
1: Disable
2: Enable (Detect)
3: Enable (Ignore)
1: Disable
How to Use the Operator Panel
90
To Next Page
Loading...
