Specifying the Sensitivity Level and Detection Range for Paper Protection [Paper
Protection Sensitivity]
You can specify the sensitivity and the detection range to detect documents that are fed abnormally when Paper
Protection is enabled.
Documents are deformed (e.g. warped, bent, creased) when they are not being fed by the rollers properly. To detect
such a symptom and stop the scan, select [Low] to only detect documents that are highly deformed, and [High] to
also detect documents that are slightly deformed.
Select [Large] when you want to widen the detection range.
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the list on the left, select [Device Setting 2] → [Paper Protection Sensitivity].
3 Specify the sensitivity for Paper Protection.
Low
Decreases the sensitivity level to detect warped documents.
Normal
Monitors the documents in normal sensitivity.
Keep this setting for normal use.
High
Increases the sensitivity level to detect warped documents.
Operational Settings
242
To Next Page
Loading...
