Fujitsu fi-7800 - Setting the Control for Ejecting Documents [Stacking Control]

Setting the Control for Ejecting Documents [Stacking Control]
Set the control for ejecting documents when scanning documents with a document length of 138 mm or shorter.
Select [Stackability Emphasis] when you want to stack the ejected documents neatly, and select [Speed Emphasis]
when you want to speed up the scanning speed.
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the list on the left, select [Device Setting 2] → [Stacking Control].
3 Specify the Stacking Control.
Stackability Emphasis
Stacks up the ejected documents neatly.
However, the scanning speed slows down with this setting.
Normal
When [Normal] is selected, the scanning speed is faster than when [Stackability Emphasis] is selected.
When [Normal] is selected, the ejected documents are stacked more neatly than when [Speed
Emphasis] is selected.
Speed Emphasis
The scanning speed becomes fast with this setting.
However, the ejected documents are not stacked neatly.
Operational Settings
250