Fujitsu fi-7800 - Sounding an Alarm When an Error Occurs [Alarm Setting]

Sounding an Alarm When an Error Occurs [Alarm setting]
Specify whether or not to sound an alarm when an error such as multifeed or paper jam occurs.
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the listing on the left, select [Device Setting 2] → [Alarm setting].
3 Configure the settings for the alarm.
Disable alarm
No alarm sounds even when an error occurs.
Low volume alarm
Sounds the alarm at low volume when an error occurs.
High volume alarm
Sounds the alarm at high volume when an error occurs.
HINT
This setting can also be configured from the operator panel.
Operational Settings
238