Fujitsu fi-7800 - Imprinter Settings [Imprinter Selection]

Imprinter Settings [Imprinter selection]
Specify which imprinter to use when both the Front-Side Imprinter and Back-Side Imprinter are installed.
This setting does not appear when no imprinter is installed.
1 Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page 193).
2 From the listing on the left, click [Device Setting 2] → [Imprinter selection].
3 Select the Imprinter to use.
Normal (obey Host specification)
Follows the scanner driver setting.
Forcibly Select Front-Side Imprinter
Forces the Front-Side Imprinter to be used unless specified otherwise by the scanner driver.
Forcibly Select Back-Side Imprinter
Forces the Back-Side Imprinter to be used unless specified otherwise by the scanner driver.
HINT
● For information about Imprinters, refer to Scanner Options (page 275).
Operational Settings
267