How to Use the Main Menu
This section explains the Main Menu.
When you press the [Menu] button in the [Ready] screen, the [Main Menu] screen is displayed.
The Main Menu can be used to configure various operational settings upon scanning.
This section explains how to use the Main Menu of the operator panel according to the following categories.
Operation Description Setting Item
Operational Settings You can configure various settings for operating the
scanner and using the operator panel.
For more details about settings, refer to Operational
Settings (page 193).
1: iMFF Setting
2: No. of Paper Feed Retries
3: Pick Speed
4: Soft Pick Setting
5: Manual Feed Timeout
6: Paper Protection
7: MF Quick Change
8: Alarm Volume
9: Stacker Positioning
10: Hopper Level
11: Paper Separation Force
12: Alarm Sound Time
13: Button Sound Vol
14: Contrast
15: Backlight ON
16: LED Blink Cycle
17: Horizontal Scroll Speed
18: Operation Panel Timeout
19: Language
20: Prioritize Panel Settings
24: Ope. Panel Initialization
26: Low-speed Feed Mode
27: Automatic Separation Control
28: Stacking Control
Cleaning the scanner You can clean the scanner by using materials such as
the Cleaning Sheet.
For more details, refer to Daily Care (page 115).
21: Cleaning
Test print for
Imprinter
You can run a test print when the imprinter is installed.
For more details, refer to the "fi-680PRF/PRB Imprinter
Operator's Guide".
22: Test Print
Checking and
resetting the
consumables/
cleaning counter
You can check the replacement cycle of the consumables
and the total page count of the maintenance parts.
Also use it to reset the counter when you have replaced
the consumables or performed cleaning.
23: Show/Clear Counters
How to Use the Operator Panel
80
To Next Page
Loading...
