Item Description Setting/Value Factory Default
- : No settings/values
When [2: Enable (Detect)] or [3: Enable
(Ignore)] is selected, it switches between
detecting/not detecting multifeed every
time the [Eject] button is pressed. It can
be switched during scanning.
For [2: Enable (Detect)], it detects
multifeed by default and multifeed
detection is performed according to the
scanner driver setting.
For [3: Enable (Ignore)], it does not detect
multifeed by default and multifeed
detection is not performed regardless of
the scanner driver setting.
8: Alarm
Volume
Specify whether or not to sound an alarm
when an error such as multifeed or paper
jam occurs.
It can also be configured from the Software
Operation Panel.
1: OFF
2: Low
3: High
1: OFF
9: Stacker
Positioning
Adjust the stacker position.
You can set the stacker at certain heights.
1: Movable
2: Fixed
(*1)
10: Hopper
Level
Change the hopper level during standby.
Selecting [1: Manual (Continuous)]
switches the scanner to Manual Feed
mode (Continuous Feed mode). The
hopper level cannot be changed in Manual
Feed mode (Single Feed mode).
Remove all documents from the hopper
when you configure this item.
The hopper is set to [4: Lower] when you
clear manual feeding (continuous).
1: Manual (Continuous)
2: Upper
3: Middle
4: Lower
(*2)
11: Paper
Separation
Force
When you experience frequent multifeeds,
pick errors or paper jams, take measures
by adjusting the force to separate the
papers.
Keep the default setting for normal use.
For details, refer to Adjusting the Paper
Separation Force (page 37).
Low ←→ High
How to Use the Operator Panel
91
To Next Page
Loading...
