Use one of the following methods to check the number of sheets that have been scanned and the amount of
remaining ink.
● You can select [23: Show/Clear Counters] from [Main Menu] on the operator panel to check the number of
sheets that have been scanned and the amount of remaining ink.
For details, refer to Checking and Resetting the Counters (page 83).
● You can start up the Software Operation Panel to check the number of sheets that have been scanned and
the amount of remaining ink.
For details, refer to Checking the Sheet Counters (page 216).
Note that the suggested replacement cycles are guidelines for using A4 (80 g/m
2
[20 lb]) wood-free or wood-
containing paper, as these cycles vary depending on the type of documents scanned and how often the scanner
is used and cleaned.
HINT
Only use the specified consumables.
For information on purchasing the consumables, contact the distributor/dealer where you purchased this
product. Refer to the contact information in the Contact List or the Contact for Inquiries section in Safety
Precautions bundled with this product and make an inquiry.
Please note that some parts (other than the consumables) need to be replaced by a service engineer,
depending on the type of documents scanned and how often the scanner is used. For instance, Maintenance
Parts (e.g. assist roller) need to be replaced by a service engineer.
For details, contact a service engineer. Refer to the contact information in the Contact List or the Contact for
Inquiries section in Safety Precautions bundled with this product and make an inquiry.
Replacing the Consumables
138
To Next Page
Loading...
