● The scanner determines that the condition of the roller has exceeded the threshold that can be corrected,
by monitoring the wear on the roller. (For assist roller counter)
● The page count after cleaning reaches 100% of the value configured in Scanner Cleaning Cycle [Cleaning
Cycle] (page 221) in the Software Operation Panel. (Cleaning counter)
● The amount of remaining ink reaches below 33%. This is only displayed when the imprinter is installed.
(For [Ink Level:Front] / [Ink Level:Back])
HINT
The total number of sheets scanned is displayed in total count. Total count cannot be reset.
5 After replacing the consumables or cleaning, select the highlighted counter with the [ ] or [ ]
button, and press the [Counter Reset] button.
A message appears to confirm that you want to clear the counter.
ATTENTION
The assist roller counter cannot be cleared.
It requires a service engineer to clear the counter.
For details, contact a service engineer. Refer to the contact information in the Contact List or the Contact
for Inquiries section in Safety Precautions bundled with this product and make an inquiry.
6 Select [1: Yes] by the [ ] or [ ] button, and press the [Function/Enter] button to confirm.
The counter value will be reset to 0.
For ink level, the value will be set to 100.
How to Use the Operator Panel
84
To Next Page
Loading...
