Fujitsu M10 User Manual

㩿㪈㪀
㩿㪋㪀
㩿㪊㪀
㩿㪉㪀
㩿㪋㪀
㩿㪈㪀
㩿㪊㪀
㩿㪉㪀
FRONT
Number in
figure
Description
1 Horizontal column
2 Vertical column
3 Horizontal connecting packing
4 Vertical connecting packing
Note -
Be careful because work on the top cover section is done high off the ground. Never
do anything dangerous such as putting your foot on the rack, which would be very dangerous.
6.
Affix connecting packings.
a. Affix vertical connecting packings 1 and 2 to the front and rear vertical
columns on the right side of expansion rack 1. You can affix either of them at
the top.
For the locations for affixing the connecting packings, see (4) in Figure 3-21.
b. Affix the
horizontal connecting packings to the horizontal column on the
upper right side of expansion rack 1.
For the locations for affixing the connecting packings, see (3) in Figure 3-21.
Figure 3-21
Affixing connecting packings
7.
Remove the screws securing the top cover of expansion rack 2, and attach M6
core spring
nuts to the front and rear of the rack.
a. Use an Allen wrench to remove the two M12 screws securing the top cover, at
the front and rear on the left side, which is the connecting side.
b. Attach two M6 core spring nuts in the lower part of the vertical
column (left
side as viewed from the front) on the connecting side at the front of the rack.
c. Attach two M6 core spring nuts in the lower part of the vertical column (right
side as viewed from the rear) on the connecting side at the rear of the rack.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 201592

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English