TX150 S6 Options Guide 69
11 Conversion standard PS to hot-
plug PS
V CAUTION!
Follow the safety instructions in the chapter “Safety instructions” on
page 15 et seq..
The standard power supply can be replaced by a hot-plug power supply. The
hot-plug power supply consists of up to two power supply modules. The upgrade
kit contains only one power supply module (for power supply redundancy the
second power supply module must be additionally ordered).
The upgrade kit for the hot-plug power supply consists of the following parts:
– PS cage with Power backplane (incl.power cables)
– locking rail
– one power supply unit
– dummy cover (if only one power supply module is installed, you have to
install the dummy cover in the second bay)
– several screws
– anti-tilt bracket
Ê Open the server as described in the chapter “Preparation” on page 21 et
seq..
Ê Disconnect all power cables from the system board and the drives (see the
cabling plans in the Appendix).
To Next Page
Loading...
