Initiating remote polling (answering machine switched on)
bt g #t#q
Dial number
(MSN-1)
Voice announcement
of the answering ma
-
chine
Enter PIN 1
Attention: You have topress»# PIN #« during the on-goingannouncement. You can carryoutfurt
-
her remote polling procedures after the positive acknowledgement signal is given.
Remote activation of a switched off answering machine
bt
After around
90 seconds
qq # PIN # q *01 q
Dial number
(MSN-1)
Request signal
Enter
PIN
Switch on answe
-
ring machine
Remote access to a switched off answering machine requires that extension number 1 (MSN-1) has
been set up an activated for an announcement.
You can carry out further remote polling procedures after the positive acknowledgement signal is gi-
ven.
Automatic forwarding (relaying) for new messages
bg#t#q
You then hear the request signal, or an infor-
mation text
Enter PIN 1
When stored, an »Forwarding announc.« will be played back at the beginning of the forwar
-
ding. If this text has not been stored or switched on, you will hear a request signal only.
If the forwarding is accepted by entering the »# PIN #« the remote polling mode for the answering
machine becomes active.
English
25
To Next Page
Loading...
