1. INSTALLATION
1-5
1. From the bottom of the radome, remove spring washers (M10), flat washers
(M10) and hex head bolts (M1025).
2. Use the mounting template (supplied) to mark the location of fixing holes in the
mounting platform. Be sure to drill the holes parallel with the bow.
3. Lay the antenna unit on the mounting platform with the bow mark() on the an-
tenna unit facing the bow.
4. Use hex bolts*, flat washers and spring washers (removed at step 1) to fasten
the radar sensor to the platform. The torque for the bolts must be 19.6 to 24.5
N.m. Apply silicone sealant (local supply) to hex bolt, flat washer and spring
washer as shown below.
*See the figure below to determine the bolt length to use.
5. Connect the power cable to the antenna unit. The pin arrangement is as shown
below.
Platform thickness Bolt size to use
5 mm or less M1020m
6 to 10 mm M1025
More than 10 mm Local supply
Hex head bolt (M10×20)
Spring washer
Flat washer
×4
Platform
Sensor base
Flat washer
Hex bolt
Spring washer
Determine the length of bolts
according to platform thickness.
Silicone sealant (local supply)
To Next Page
Loading...
