1. INSTALLATION
1-6
How to connect the power cable
Observe the following guidelines for connecting the power cable.
• The connectors must not strike any part of the vessel by wind, etc.
• The load applied to the connectors must not be more than their own weight.
• If the cable is passed through a mast on a sailboat, be sure the cable does not
touch ropes (sheet, halyard, etc.).
• Do not fasten the cable to the hull.
1. The cable must be fixed so no tension is applied to the connectors. To prevent
tension, make a loop in the cable close to the sensor and tie the loop with cable
ties, as in the figure below.
2. Wrap the junction of the connectors with self vulcanizing tape for waterproofing.
3. Fasten the cable to the mast, etc. at the neck of each connector with a cable tie.
How to use the radome mounting bracket (option)
The optional radome mount lets you fasten the radar sensor to a mast on a sailboat.
Name, Type: Radome Mount, OP03-209
Code No.: 001-078-350
Name Type Code No. Qty
Mounting plate 03-018-9001-0 100-206-740-10 1
Support plate (1) 03-018-9005-0 100-206-780-10 1
Support plate (2) 03-018-9006-0 100-206-790-10 1
Bracket (1) 03-028-9101-1 100-206-811-10 1
Bracket (2) 03-028-9101-2 100-206-812-10 1
Fixing plate 03-028-9103-1 100-206-831-10 2
Hex bolt w/washer M820 SUS304 000-162-955-10 8
Hex bolt w/washer M412 SUS304 000-162-956-10 4
Loop cable and tie the loop with cable
ties. (Min. bending radius: 80 mm)
Connect and wrap with tape.
To Next Page
Loading...
