11. Chart Alarms
11-11
11.5.1 Finding chart alarms leg by leg
After you have done chart alarm calculation, the system is able to show you legs on the route where danger areas are
located. All the alarms for each leg where alarms occur are shown in the Alarms list. The list of alarms is based on
selections made in the Chart alarm parameters sub menu. To find chart alarms by route leg, do the following:
1. In the Check page of the Plan Route dialog box, the Alarms by leg field has a selection box where you may
choose desired leg number.
2. Choose the Alarm from the Alarms by leg field and then click Locate leg button. The system will display
chosen leg on the electronic chart area as shown below.
To Next Page
Loading...
