Furuno FEA-2107 - 6.6.2 Recalculating Timetable and ETA Values

6. Setup Before Departure
6-3
To store selections on the Alarms page, click the Start button. Also, the name of the user chart and the name of pilot
data, which were chosen as planning mode, are stored in this route.
6.6.2 Recalculating timetable and ETA values
Timetable and ETA values can be recalculated from the Parameters page in the Plan Route dialog box. Minimally
set ETD to equal departure time, and perform desired optimization.
0$
After checking the chart alarms and setting the ETD, cancel selection of the planned route in order to enable the
selection of it as the route to be monitored, using “Unselect” in the Plan Route menu, or use “Exchange with
Monitored” on the same sub menu to choose it directly as monitored route.