Furuno FEA-2107 - Choosing Pilot Data to Use in Monitoring Mode

16. Pilot Data
16-4
16.3 Choosing Pilot Data to use in Monitoring Mode
Pilot data which is for system use is displayed in the pilot data field on the status bar. If the text “PilotData” is red
this means that the workstation is in the planning mode for pilot data. To activate the monitoring mode and choose
pilot data for the monitoring mode, do the following:
Place cursor here,
spin thumbwheel to
choose pilot data
and push thumbwheel.
North Up TM
ECDIS only
Posn true
HDG 070.0°
SPD
(CALC)
1.8 Kt
SB
(POSN)
1.7 Kt
COG
(POSN)
045.1°
SOG
(POSN)
2.0 Kt