3. ECDIS Screen
3-10
3.3.3 Activating dialog boxes on the display
There are several dialog boxes which can be activated by mouse-clicking over certain areas on the ECDIS display.
Place the cursor over the appropriate area and then click the right or left mouse button to display the corresponding
dialog box on the ECDIS display. See the figure below to find the places and mouse button to click to get desired
dialog boxes on the display. To close a dialog box, click the X at the top right corner of the dialog box. Note that
only one dialog box may be shown at a time.
SET TIME
ALARM
QUEUE
NAV.
MARKS
MON.
ROUTE
SENSORS
PLAN ROUTE
North Up TM
HDG 070.0°
SPD
(CALC)
1.8
Kt
SB
(POSN)
1.7
Kt
COG
(POSN)
045.1°
SOG
(POSN)
2.0
Kt
ECDIS only
Spd/Cse
Rate gyro
To Next Page
Loading...
