13. Route Planning
13-10
Dragging and dropping waypoint to new position
1. Place the cursor on Route in the status bar, click Plan to open the Plan Route dialog box and then click the WP
tab.
2. Check Enable changes, and then place the cursor on the waypoint you want to process.
3. Press and hold down the left mouse button while rolling the trackball to move the cursor to a desired position.
Keep the button pressed down while you move the cursor and release it when the cursor is at desired position.
North Up TM
ECDIS only
Posn true
HDG 070.0°
SPD
(CALC)
1.8
Kt
SB
(POSN)
1.7
Kt
COG
(POSN)
045.1°
SOG
(POSN)
2.0
Kt
Drag and drop waypoint to new position (in this case waypoint number 9 is taken to a new position)
13.5.3 Changing other waypoint data
To change other data of a waypoint, such as name, steering mode, turning radius, min/max speed, do the following:
1. Place the cursor on a desired field and spin the thumbwheel to change data.
2. Push the thumbwheel to confirm changes.
To Next Page
Loading...
