13. Route Planning
13-9
Entering latitude and longitude in position field
1. Place the cursor on Route in the status bar, click the Plan button to open the Plan Route dialog box and then
click the WP tab.
2. Check Enable changes, and then choose desired WP. Place the cursor in the Lat or Lon field as appropriate, spin
the thumbwheel to set co-ordinates and then push the thumbwheel to confirm.
Entering distance and direction for next waypoint
Position of WP can be defined using distance and direction between two waypoints.
1. Place the cursor on Route in the status bar, click Plan to open the Plan Route dialog box and then click the WP
tab.
2. Check Enable changes, and then highlight number of WP by cursor and then push the left mouse button.
3. Click the Next WP button, and the following dialog box appears.
4. Enter Direction and Distance in respective box in the Next WP field and then click the OK button.
To Next Page
Loading...
