1. INITIAL SETTINGS AND ADJUSTMENTS
1-16
4. Click [Serial Input/Output] of [No.1 ECDIS] on the menu bar.
The PCU-3010 has four serial interface ports ([Serial 01] to [Serial 04]).
[Serial 01] and [Serial 02] can input/output at 38,400 bps. For high-speed signal
input (such as AIS and Gyro), click [Details] to set the baud rate as 38,400 bps.
The connector no. on the I/O board of the panel computer unit PCU-3010 and the
corresponding serial port no. are shown in following tale.
5. Check the applicable checkboxes of [Serial No.] according to sensor connection.
6. Set the items referring to the table shown below.
[VNC Connection
Enable]
Not used.
[Sub Display
Mode]
[Server IP
Address]
[Server Port
Number]
[Server Login
Password]
[Additional
Parameters]
Connector No. Serial Port No. Connector No. Serial Port No.
COM1 (C1) Serial 01 COM3 (C3) Serial 03
COM2 (C2) Serial 02 COM4 (C4) Serial 04
Item Remarks
To Next Page
Loading...
