Furuno FMD-3100 - Page 66

1. INITIAL SETTINGS AND ADJUSTMENTS
1-60
[Source]: Select the data source same as [Object 1] or [Object 2] to show the ab-
breviated name of the data source unit.
[Label]: Enter the data name of [Object 1 (or 2)].
[Limit]: Set the digit number of the data of [Object 1 (or 2)].
[Source]: Select the data source of [Object 1 (or 2)].
[Zero Padding]: Set the number of decimal points to show "0" in the [Source] for
each object.
[Unit]: Set the unit of data for [Object 1 (or 2)].
• Rudder
[Title]: Enter the title of the component.
[Location]: Select the rudder location from the pull-down list.
[Rudder Title]: Enter the title of the [Rudder 1 (or 2)] indicator.
[Primary Source]: Select the data source of the long pointer of [Rudder 1 (or 2)] in-
dicator.
[Secondary Source]: Select the data source of the long pointer of [Rudder 1 (or 2)]
indicator.
[Max Angle]: Set the maximum rudder angle of [Rudder 1 (or 2)] indicator.
[Scale Resolution]: Select the scale resolution.
[Mathematical Sign]: Check the checkbox to show the minus sign (-) when the value
is minus.
[Zero Padding]: Set the number of decimal points to show "0" in the [Source] for
each object.
[Unit]: Set the unit of data for [Object 1 (or 2)].
• [Stabilizer Status]
[Title]: Enter the title of the component.
[Object1 (to 4)]
[Label]: Enter the data name of [Object 1 (or 2)].
[Source]: Select the data source of [Object 1 (or 2)].
• [Steering Mode]