Furuno RD-33 - Setting Programmed Screens

2. PROGRAMMED SCREEN
2-2
2. Use the Cursorpad (S or T) to select [Display] and press the ENT key.
3. Use the Cursorpad (S or T) to select [Graphic] and press the ENT key.
4. Use the Cursorpad (S or T) to select [A] or [B] then press the ENT key.
5. Press the DISP key to close the menu and display the data screen.
2.2 How to Set the Programmed Screen
The RD-33 provides six programmed screens and each screen has four preset
screens. You can select one of them as the data screen.
1. Press the MENU key to open the menu.
2. Use the Cursorpad (S or T) to select [Display] and press the ENT key.
3. Use the Cursorpad (S or T) to select [Display1] and press the ENT key.
Display options for [Display1]
4. Use the Cursorpad (S or T) to select [Fishing], [Sailing], [Ship], [Navigation], [En-
vironment] or [Engine] then press the ENT key. The data for these items are pre-
set and arranged for general navigation purposes. See the table on page 2-4 for
each menu item.