3. CUSTOM SCREEN
3-15
How to change the unit
You can select the XTE unit from nm, km or sm as follows:
1. With the data screen for XTE displayed, press the ENT key.
2. Press the ENT key long.
3. Use the Cursorpad (S or T) to select [Unit] and press the ENT key.
4. Use the Cursorpad (S or T) to select [nm], [km] or [sm] then press the ENT key.
5. Press the DISP key to close the menu and display the data screen.
How to change the scale range
You can change the scale range for analog XTE. With the data screen for XTE dis-
played, use the Cursorpad to change the scale range.
S, X: Increase the numeric value.
T, W: Decrease the numeric value.
Note: When the XTE exceeds the setting scale range, the red triangle mark on the
highway screen flashes.
3.8 How to Switch the Digital Data for Heading and
Wind Angle
You can switch the digital data on the analog screen as follows.
Heading (Available for )
Use the Cursorpad (X) to switch the digital data for heading. The digital data changes
as follows. The data changes in reverse order with the Cursorpad (W).
Unit Scale range
nm 0.2, 0.4, 0.8, 1.0, 2.0, 4.0, 8.0, 16.0
km 0.2, 0.4, 1.0, 2.0, 4.0, 10.0, 20.0, 30.0
sm 0.2, 0.4, 0.8, 1.0, 2.0, 4.0, 8.0, 16.0
,,,
To Next Page
Loading...
