97
NOTE: Take care not to accidentally cut the wires when you cut the zip ties.
Now the print head is free of the printer.
NOTE:
DO NOT DISASSEMBLE THE PRINT HEAD FURTHER THAN THIS. Doing so can damage
components and cause it to not work properly.
DO NOT ATTEMPT TO REMOVE THE NOZZLE FROM THE HOT BLOCK.
IF YOUR PRINT HEAD IS JAMMED, please see section 13.3.
12.10.2 Installing
IMPORTANT: Make sure the PTFE liner is present in the top of the print head! When the head is
removed these can fall out and sometimes people don’t notice. The print head will not perform properly
without this liner!
To Next Page
Loading...
