FUTABA 8FG - Page 104

104
<Model Menu (Airplane/Glider Functions)>
Setting method
● Activate the motor speed function
When using motor speed function, move the
cursor to the [INH] item and touch the RTN
button to switch to the data input mode.
Select the [ACT] by scrolling the touch sensor
and touch the RTN button.
● Sifting the boundary between the 2 ranges
Move the cursor to the [SPEED 1>2] item and
touch the RTN button to switch to the data
input mode.
Adjust the boundary position by scrolling the
touch sensor.
 Initialvalue:0%
 Adjustmentrange:-100~+100%
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
● Operation speed adjustment
Move the cursor to the [IN] (on to off) or [OUT]
(off to on) item and touch the RTN button to
switch to the data input mode.
Adjust the operation speed you want to set
by scrolling the touch sensor.
Initial value: 0
Adjustment range: 0~27
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
●ON/OFFdirection
● Motor function switch
current position
● Set/Reset the one time operation
Move the cursor to the [ONE TIME] item and
touch the RTN button to switch to the data
input mode.
Select the [ACT] by scrolling the touch sensor
and touch the RTN button to set the one time
operation.
* When you want to reset one time operation, set the ACT/
INH item to [INH] and then reset it to [ON].