FUTABA 8FG - Receiver Modes and Range Testing

25
<Basic Operation>
Operation Mode Select (R6008HS)
The receiver operation mode is on "Normal mode" from factory shipping. To change the mode, please
adhere to the following steps:
Changing the operation mode
LED
Link/Mode Button
1. Turn off the receiver.
2. Press and hold the Link/Mode button and
turn on the receiver. Continue holding the
button for more than one(1) second. The LED
beginsashingtoindicatethecurrentstatus.
3. Release the button.
4. Turn off the receiver.
By doing so, the receiver will change modes.
Conrming the operation mode
Please check the operation mode by observing
the LED when turning on the receiver.
If possible ensure that there's no FASST
transmitter in operation near the receiver.
1. When the receiver is turned on:
Red when on "Normal mode"
Initially flashes green and Red (making
Orange) when in "High Speed mode". After
two(2) seconds, change to Red.
If there are additional FASST transmitters turned
on near the receiver, the LED may show the above
status for a brief moment before changing to the
status indication as shown in the "LED indication"
table below.
LED Indication (R6008HS)
Green Red Status
Off Solid No signal reception
Solid Off Receiving signals
Blink Off
Receiving signals but ID is
unmatched
0 to 1 sec. More than 1 sec.
0 sec. 1 sec.
Press and Hold time
Turn on the receiver.
No function
Showing the CURRENT
mode with blink.
Red Blink = Normal
Green/Red Blink =
High Speed
Solid as the mode changed.
Red Solid = Normal
Green/Red Solid = High
Speed
(Become Red after one (1)
second)
（Function）
To change the mode between
Normal and High Speed
（LED Status）
(Operation Mode Select)