FUTABA 8FG - Idle down (Air Only)

63
<Functions of Linkage Menu>
●Selectthefunction name
and return to the Linkage
menu by touching the
RTN button.
<SensorTouch™>
IDLE DOWN
Lowers the engine idling speed.(airplane only)
The Idle Down function lowers the engine to
its idle position. Like Throttle Cut, this is usually
accomplished by ipping a switch with the throttle
stick at idle. The action is not functional at high
throttle to avoid accidental dead sticks. The switch’
s location and direction must be chosen, as it
defaults to NULL.
Idle down setting procedure
1. Activate the function:
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode.
Select the ACT mode by scrolling the touch
sensor.
*The display blinks.
Tou ch the RTN butto n t o a ctiva te the
function and return to the cursor mode.
2. Switch selection:
Move the cursor to the [SW] item and access
the switch setup screen by touching the RTN
button. Select the switch and ON direction.
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
3. Offset rate setting:
Move the cursor to the [OFFSET] item and
touch the RTN button to switch to the data
input mode.
Adjust the servo offset rate at idle down
operation by scrolling the touch sensor.
 Initialvalue:0%
 Adjustmentrange:0%~100%
*When the RTN button is touched for one second, the offset
rate is reset to the initial value.
*Maximum offset amount is near maximum slow.
Touch the RTN button to end the adjustment
and return to the cursor mode.
● Select [IDLE DOWN] in the Linkage menu and
access the setup screen shown below by touching
the RTN button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Currentthrottleposition