FUTABA 8FG - RUD to AIL

87
<Model Menu (Airplane/Glider Functions)>
●Selectthefunction name
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
RUDDER 2
RUDDER
RUDDER
V-TAIL
RUDDER 2
Winglet
RUDDER 1
Winglet
at Flying wing at Flying wing
( )
( )
AIL 3 AIL 3
(Chip Aileron)
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
RUD to AIL
[Corresponding model type]: Airplane/glider, general
This function is used when you want to mix
the ailerons with rudder input. It is used when
rudder is applied during roll maneuvers such
as, knife edge flight. It can be used to turn or
bank scale models, large models, etc. like a full-
size aircraft.
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
●Linkingcanbeset:Linkthismixtoothermixes.
●Themixingratecanalsobeadjusted.
● Select [RUD to AIL] at the Model
menu and access the setup screen
shown below by touching the RTN
button.
*The display screen is an example.
The actual screen depends on the
model type.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
Setting method
●Activate the function
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode. Select the ACT mode by scrolling the
touch sensor.
*The display blinks.
Tou ch the RTN butto n t o a ctiva te the
function and return to the cursor mode. (ON
is displayed.)
When setting a switch, move the cursor to
the [SW] item and touch the RTN button to
call the selection screen. Select the switch
and set its ON direction. (Always ON at "--"
setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Mixing rate adjustment
Move the cursor to the left or right item
and touch the RTN button to switch to the
data input mode. Adjust the mixing rate
independently by scrolling the touch sensor.
 Initialvalue:0%
 Adjustmentrange:-100~+100%
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to end the adjustment
and return to the cursor mode.
●Link mode setting
To activate the link mixing, move the cursor
to the [LINK] item and touch the RTN button
to switch to the data input mode. Select the
ON mode by scrolling the touch sensor.
*The display blinks.
Touch the RTN button to set the link mode
and return to the cursor mode.
(Glider: Currently selected condition name)