FUTABA 8FG - Trim MIX (Glid Only, 2-AIL and Up)

94
<Model Menu (Airplane/Glider Functions)>
●Selectthefunction name
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
TRIM MIX
[Corresponding model type]: Glider, 2 ailerons or more
This function adjusts the trim offset rates of the
ailerons, elevators, and aps (camber aps, brake
aps) according to the ight status.
As an example this function can be set up for
launching, with speed aps and ailerons drooped,
and a slight amount of up elevator, and can be
used for high speed ying, with both ailerons and
speed flaps reflexed slightly, and a bit of down
elevator.
To prevent sudden trim changes when switching
ight conditions, a delay can be set to provide a
● Select [TRIM MIX] at theModelmenu
and access the setup screen shown
below by touching the RTN button.
*The display screen is an example. The actual
screen depends on the model type.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
smooth transition between the two conditions. It
is also possible to program a cut switch which
will turn off the delay.
Furthermore, you can set the auto switch, which
will link the trim mix to a stick, switch, or dial.
Additionally, the speed of the aileron, elevator,
and ap servos can be adjusted.
(Currently selected condition name)
●Conditiondelay
setting
● Ail erons , flaps , a nd
elevators servo speed
setting
●Autoswitchselection
●  A i l e r o n s ,  f l a p s ,  a n d
elevators offset rate
● S w i t c h
selection